Replacing front brake pads (catalog number 7701207066) is produced in the case of the wear limit their plates – the minimum thickness of pads, including its base, shall not be less than 8mm. Pads also need to be replaced by replacing disk brake assembly, oiling or the presence of overlap in these deep grooves, cracks and chips, as well as in the case of detachment from the base pad linings. Usually the lifetime of the front brake pads for Renault Logan is 30–40 thousand miles. Need to replace the pads occurs when gnashing or whistling when braking. The front pads on the Renault Logan is set to change only – all four blocks. Replacement pads only one brake mechanism leading to transfer into the car to one side when braking.
If the fluid level in hydraulic brake reservoir is on the mark “MAX”, then before installing new pads or rubber bulb syringe pumped from a tank of liquid. This operation is required to ensure that in the “retraction” of the piston in the wheel cylinder brake during the installation of new pad fluid is leaking from under the tank lid. Remove the front wheel. Before installing new pads as necessary to move the wheel cylinder piston inside the cylinder. For this purpose, inserting through a hole in the caliper with a screwdriver blade between a wide ground pads and external caliper, and based it on the slide, move the bracket utaplivaya piston in the cylinder.
Spanner wrenches “to 13” turn away bolt the brackets to the bottom of guide fingers, hold your finger carob key “to 17”. Picking up the bracket, remove the brake pads from their guide. Remove the two spring clips pads. Wire brush clean of dirt and corrosion seating pads in their guide. Before installing new shoes check the status of protective covers guide fingers. Torn or lost elasticity cover is replaced. To do this, take out the guide pin holes of the guide blocks and replace the cover (for replacing the cover of the upper guide pin to unscrew the bolt clamps the finger and remove the bracket from the guide pads). Before installing your finger put a little grease to the guide hole pads and apply a thin layer of grease on the surface of the finger. Install new brake pads in the guide blocks and drop bracket. If the serving of the wheel cylinder piston that prevents installation of the slide the brake pads, then lift the sliding clamp and pliers utaplivayut piston in the cylinder. Similarly, replace the pads on the other side of the car. After replacing the pads a few times to push the brake pedal installation clearance between pads and discs. Check the fluid level in the tank and if necessary, we bring it back to normal. In the operation of the disc brake becomes uneven, resulting in contact area of the new, not yet bedded brake pads with the disc decreases. Therefore, during the first 50 km run after replacing the pads, while new ones will not run–block, be careful, because Car braking distance increases. In addition to the original brake pads manufactured weight counterparts.